community.network.apconos_command module – Run arbitrary commands on APCON devices

Note

This module is part of the community.network collection (version 5.1.0).

You might already have this collection installed if you are using the ansible package. It is not included in ansible-core. To check whether it is installed, run ansible-galaxy collection list.

To install it, use: ansible-galaxy collection install community.network.

To use it in a playbook, specify: community.network.apconos_command.

Note

The community.network collection has been deprecated and will be removed from Ansible 12. See the discussion thread for more information.

New in community.network 0.2.0

DEPRECATED

Removed in:

version 6.0.0

Why:

This collection and all content in it is unmaintained and deprecated.

Alternative:

Unknown.

Synopsis

  • Sends arbitrary commands to an apcon device and returns the results read from the device. The module includes an argument that will cause the module to wait for a specific condition before returning or timing out if the condition is not met.

Aliases: network.apconos.apconos_command

Parameters

Parameter

Comments

commands

list / elements=string / required

List of commands to send to the remote device over the configured provider. The resulting output from the command is returned. If the wait_for argument is provided, the module is not returned until the condition is satisfied or the number of retires as expired.

interval

integer

Configures the interval in seconds to wait between retries of the command. If the command does not pass the specified conditions, the interval indicates how long to wait before trying the command again.

Default: 1

match

string

The match argument is used in conjunction with the wait_for argument to specify the match policy. Valid values are all or any. If the value is set to all then all conditionals in the wait_for must be satisfied. If the value is set to any then only one of the values must be satisfied.

Choices:

  • "any"

  • "all" ← (default)

retries

integer

Specifies the number of retries a command should by tried before it is considered failed. The command is run on the target device every retry and evaluated against the wait_for conditions.

Default: 10

wait_for

list / elements=string

List of conditions to evaluate against the output of the command. The task will wait for each condition to be true before moving forward. If the conditional is not true within the configured number of retries, the task fails. See examples.

Notes

Note

  • Tested against apcon iis+ii

Examples

- name: Basic Configuration
  community.network.apconos_command:
    commands:
    - show version
    - enable ssh
  register: result

- name: Get output from single command
  community.network.apconos_command:
    commands: ['show version']
  register: result

Status

  • This module will be removed in version 6.0.0. [deprecated]

  • For more information see DEPRECATED.

Authors

  • David Lee (@davidlee-ap)