community.network.edgeos_command – Run one or more commands on EdgeOS devices

Note

This plugin is part of the community.network collection (version 1.3.2).

To install it use: ansible-galaxy collection install community.network.

To use it in a playbook, specify: community.network.edgeos_command.

Synopsis

• This command module allows running one or more commands on a remote device running EdgeOS, such as the Ubiquiti EdgeRouter.

• This module does not support running commands in configuration mode.

• Certain show commands in EdgeOS produce many lines of output and use a custom pager that can cause this module to hang. If the value of the environment variable ANSIBLE_EDGEOS_TERMINAL_LENGTH is not set, the default number of 10000 is used.

• This is a network module and requires connection: network_cli in order to work properly.

• For more information please see the Network Guide.

Parameters

Parameter	Choices/Defaults	Comments
commands string / required		The commands or ordered set of commands that should be run against the remote device. The output of the command is returned to the playbook. If the wait_for argument is provided, the module is not returned until the condition is met or the number of retries is exceeded.
interval string	Default: 1	The number of seconds to wait between retries of the command.
match string	Choices: any all ←	Used in conjunction with wait_for to create match policy. If set to all, then all conditions in wait_for must be met. If set to any, then only one condition must match.
retries string	Default: 10	Number of times a command should be tried before it is considered failed. The command is run on the target device and evaluated against the wait_for conditionals.
wait_for string		Causes the task to wait for a specific condition to be met before moving forward. If the condition is not met before the specified number of retries is exceeded, the task will fail.

Notes

Note

• Tested against EdgeOS 1.9.7

• Running show system boot-messages all will cause the module to hang since EdgeOS is using a custom pager setting to display the output of that command.

Examples

tasks:
  - name: Reboot the device
    community.network.edgeos_command:
      commands: reboot now

  - name: Show the configuration for eth0 and eth1
    community.network.edgeos_command:
      commands: show interfaces ethernet {{ item }}
    loop:
      - eth0
      - eth1

Return Values

Common return values are documented here, the following are the fields unique to this module:

Key	Returned	Description
stdout list / elements=string	always apart from low level errors (such as action plugin)	The set of responses from the commands Sample: ['...', '...']
stdout_lines list / elements=string	always	The value of stdout split into a list Sample: [['...', '...'], ['...'], ['...']]

Authors

• Chad Norgan (@beardymcbeards)

• Sam Doran (@samdoran)