community.network.slxos_interface – Manage Interfaces on Extreme SLX-OS network devices

Note

This plugin is part of the community.network collection (version 1.3.2).

To install it use: ansible-galaxy collection install community.network.

To use it in a playbook, specify: community.network.slxos_interface.

Synopsis

• This module provides declarative management of Interfaces on Extreme SLX-OS network devices.

Parameters

Parameter		Choices/Defaults	Comments
aggregate string			List of Interfaces definitions.
delay string		Default: 10	Time in seconds to wait before checking for the operational state on remote device. This wait is applicable for operational state argument which are state with values up/down, tx_rate and rx_rate.
description string			Description of Interface.
enabled boolean		Choices: no yes ←	Interface link status.
mtu string			Maximum size of transmit packet.
name string / required			Name of the Interface.
neighbors string			Check the operational state of given interface name for LLDP neighbor. The following suboptions are available.
	host string		LLDP neighbor host for given interface name.
	port string		LLDP neighbor port to which given interface name is connected.
rx_rate string			Receiver rate in bits per second (bps).
speed string			Interface link speed.
state string		Choices: present ← absent up down	State of the Interface configuration, up means present and operationally up and down means present and operationally down
tx_rate string			Transmit rate in bits per second (bps).

Notes

Note

• Tested against SLX-OS 17s.1.02

Examples

- name: Configure interface
  community.network.slxos_interface:
      name: Ethernet 0/2
      description: test-interface
      speed: 1000
      mtu: 9216

- name: Remove interface
  community.network.slxos_interface:
    name: Loopback 9
    state: absent

- name: Make interface up
  community.network.slxos_interface:
    name: Ethernet 0/2
    enabled: True

- name: Make interface down
  community.network.slxos_interface:
    name: Ethernet 0/2
    enabled: False

- name: Check intent arguments
  community.network.slxos_interface:
    name: Ethernet 0/2
    state: up
    tx_rate: ge(0)
    rx_rate: le(0)

- name: Check neighbors intent arguments
  community.network.slxos_interface:
    name: Ethernet 0/41
    neighbors:
    - port: Ethernet 0/41
      host: SLX

- name: Config + intent
  community.network.slxos_interface:
    name: Ethernet 0/2
    enabled: False
    state: down

- name: Add interface using aggregate
  community.network.slxos_interface:
    aggregate:
    - { name: Ethernet 0/1, mtu: 1548, description: test-interface-1 }
    - { name: Ethernet 0/2, mtu: 1548, description: test-interface-2 }
    speed: 10000
    state: present

- name: Delete interface using aggregate
  community.network.slxos_interface:
    aggregate:
    - name: Loopback 9
    - name: Loopback 10
    state: absent

Return Values

Common return values are documented here, the following are the fields unique to this module:

Key	Returned	Description
commands list / elements=string	always, except for the platforms that use Netconf transport to manage the device.	The list of configuration mode commands to send to the device. Sample: ['interface Ethernet 0/2', 'description test-interface', 'mtu 1548']

Authors

• Lindsay Hill (@LindsayHill)