onyx_l3_interface – Manage L3 interfaces on Mellanox ONYX network devices

New in version 2.5.

Synopsis

  • This module provides declarative management of L3 interfaces on Mellanox ONYX network devices.

Parameters

Parameter Choices/Defaults Comments
aggregate
-
List of L3 interfaces definitions
ipv4
-
IPv4 of the L3 interface.
ipv6
-
IPv6 of the L3 interface (not supported for now).
name
-
Name of the L3 interface.
purge
boolean
    Choices:
  • no ←
  • yes
Purge L3 interfaces not defined in the aggregate parameter.
state
-
    Choices:
  • present ←
  • absent
State of the L3 interface configuration.

Examples

- name: Set Eth1/1 IPv4 address
  onyx_l3_interface:
    name: Eth1/1
    ipv4: 192.168.0.1/24

- name: Remove Eth1/1 IPv4 address
  onyx_l3_interface:
    name: Eth1/1
    state: absent

- name: Set IP addresses on aggregate
  onyx_l3_interface:
    aggregate:
      - { name: Eth1/1, ipv4: 192.168.2.10/24 }
      - { name: Eth1/2, ipv4: 192.168.3.10/24 }

- name: Remove IP addresses on aggregate
  onyx_l3_interface:
    aggregate:
      - { name: Eth1/1, ipv4: 192.168.2.10/24 }
      - { name: Eth1/2, ipv4: 192.168.3.10/24 }
    state: absent

Return Values

Common return values are documented here, the following are the fields unique to this module:

Key Returned Description
commands
list
 always.
The list of configuration mode commands to send to the device

Sample:
['interfaces ethernet 1/1 ip address 192.168.0.1 /24']


Status

Authors

  • Samer Deeb (@samerd)

Hint

If you notice any issues in this documentation you can edit this document to improve it.