vyos_lldp_interface – Manage LLDP interfaces configuration on VyOS network devices

New in version 2.4.

Synopsis

  • This module provides declarative management of LLDP interfaces configuration on VyOS network devices.

Parameters

Parameter Choices/Defaults Comments
aggregate
-
List of interfaces LLDP should be configured on.
name
-
Name of the interface LLDP should be configured on.
provider
-
Deprecated
Starting with Ansible 2.5 we recommend using connection: network_cli.
For more information please see the Network Guide.

A dict object containing connection details.
host
- / required
Specifies the DNS host name or address for connecting to the remote device over the specified transport. The value of host is used as the destination address for the transport.
password
-
Specifies the password to use to authenticate the connection to the remote device. This value is used to authenticate the SSH session. If the value is not specified in the task, the value of environment variable ANSIBLE_NET_PASSWORD will be used instead.
port
-
Default:
22
Specifies the port to use when building the connection to the remote device.
ssh_keyfile
-
Specifies the SSH key to use to authenticate the connection to the remote device. This value is the path to the key used to authenticate the SSH session. If the value is not specified in the task, the value of environment variable ANSIBLE_NET_SSH_KEYFILE will be used instead.
timeout
-
Default:
10
Specifies the timeout in seconds for communicating with the network device for either connecting or sending commands. If the timeout is exceeded before the operation is completed, the module will error.
username
-
Configures the username to use to authenticate the connection to the remote device. This value is used to authenticate the SSH session. If the value is not specified in the task, the value of environment variable ANSIBLE_NET_USERNAME will be used instead.
state
-
    Choices:
  • present ←
  • absent
  • enabled
  • disabled
State of the LLDP configuration.

Notes

Note

  • Tested against VYOS 1.1.7
  • For more information on using Ansible to manage network devices see the Ansible Network Guide

Examples

- name: Enable LLDP on eth1
  net_lldp_interface:
    state: present

- name: Enable LLDP on specific interfaces
  net_lldp_interface:
    interfaces:
      - eth1
      - eth2
    state: present

- name: Disable LLDP globally
  net_lldp_interface:
    state: disabled

- name: Create aggregate of LLDP interface configurations
  vyos_lldp_interface:
    aggregate:
    - name: eth1
    - name: eth2
    state: present

- name: Delete aggregate of LLDP interface configurations
  vyos_lldp_interface:
    aggregate:
    - name: eth1
    - name: eth2
    state: absent

Return Values

Common return values are documented here, the following are the fields unique to this module:

Key Returned Description
commands
list
always, except for the platforms that use Netconf transport to manage the device.
The list of configuration mode commands to send to the device

Sample:
['set service lldp eth1', 'set service lldp eth2 disable']


Status

Red Hat Support

More information about Red Hat’s support of this module is available from this Red Hat Knowledge Base article.

Authors

  • Ricardo Carrillo Cruz (@rcarrillocruz)

Hint

If you notice any issues in this documentation you can edit this document to improve it.