net_lldp_interface – Manage LLDP interfaces configuration on network devices

New in version 2.4.

Synopsis

  • This module provides declarative management of LLDP interfaces configuration on network devices.

Parameters

Parameter Choices/Defaults Comments
aggregate
-
List of interfaces LLDP should be configured on.
name
-
Name of the interface LLDP should be configured on.
purge
-
Default:
"no"
Purge interfaces not defined in the aggregate parameter.
state
-
    Choices:
  • present ←
  • absent
  • enabled
  • disabled
State of the LLDP configuration.

Notes

Note

Examples

- name: Configure LLDP on specific interfaces
  net_lldp_interface:
    name: eth1
    state: present

- name: Disable LLDP on specific interfaces
  net_lldp_interface:
    name: eth1
    state: disabled

- name: Enable LLDP on specific interfaces
  net_lldp_interface:
    name: eth1
    state: enabled

- name: Delete LLDP on specific interfaces
  net_lldp_interface:
    name: eth1
    state: absent

- name: Create aggregate of LLDP interface configurations
  net_lldp_interface:
    aggregate:
    - { name: eth1 }
    - { name: eth2 }
    state: present

- name: Delete aggregate of LLDP interface configurations
  net_lldp_interface:
    aggregate:
    - { name: eth1 }
    - { name: eth2 }
    state: absent

Return Values

Common return values are documented here, the following are the fields unique to this module:

Key Returned Description
commands
list
 always, except for the platforms that use Netconf transport to manage the device.
The list of configuration mode commands to send to the device

Sample:
['set service lldp eth1 disable']


Status

Red Hat Support

More information about Red Hat’s support of this module is available from this Red Hat Knowledge Base article.

Authors

  • Ganesh Nalawade (@ganeshrn)

Hint

If you notice any issues in this documentation you can edit this document to improve it.