onyx_igmp_vlan – Configures IGMP Vlan parameters

New in version 2.8.

Synopsis

  • This module provides declarative management of IGMP vlan configuration on Mellanox ONYX network devices.

Parameters

Parameter Choices/Defaults Comments
mrouter
-
Configure ip igmp snooping mrouter port on vlan
name
- / required
Configure mrouter interface
state
-
    Choices:
  • enabled ←
  • disabled
Enable IGMP snooping mrouter on vlan interface.
querier
-
Configure the IGMP querier parameters
address
-
Update IP address for the querier
interval
-
Update time interval between querier queries, range 60-600
state
-
    Choices:
  • enabled ←
  • disabled
Enable IGMP snooping querier on vlan in the switch.
state
-
    Choices:
  • enabled ←
  • disabled
IGMP state.
static_groups
-
List of IGMP static groups.
multicast_ip_address
- / required
Configure static IP multicast group, range 224.0.1.0-239.255.255.25.
name
-
interface name to configure static groups on it.
sources
-
List of IP sources to be configured
version
-
    Choices:
  • V2
  • V3
IGMP snooping operation version on this vlan
vlan_id
- / required
VLAN ID, vlan should exist.

Notes

Note

  • Tested on ONYX 3.7.0932-01

Examples

- name: configure igmp vlan
  onyx_igmp_vlan:
    state: enabled
    vlan_id: 10
    version:
      V2
    querier:
      state: enabled
      interval: 70
      address: 10.11.121.13
    mrouter:
      state: disabled
      name: Eth1/2
    static_groups:
      - multicast_ip_address: 224.5.5.8
        name: Eth1/1
        sources:
          - 1.1.1.1
          - 1.1.1.2

Return Values

Common return values are documented here, the following are the fields unique to this module:

Key Returned Description
commands
list
always
The list of configuration mode commands to send to the device.

Sample:
['vlan 10 ip igmp snooping', 'vlan 10 ip igmp snooping static-group 224.5.5.5 interface ethernet 1/1']


Status

Authors

  • Anas Badaha (@anasbadaha)

Hint

If you notice any issues in this documentation you can edit this document to improve it.