onyx_ptp_interface – Configures PTP on interface

New in version 2.8.

Synopsis

  • This module provides declarative management of PTP interfaces configuration on Mellanox ONYX network devices.

Parameters

Parameter Choices/Defaults Comments
announce_interval
-
configure PTP announce setting for interval, Range -3-1
announce_timeout
-
configure PTP announce setting for timeout, Range 2-10
delay_request
-
configure PTP delay request interval, Range 0-5
name
- / required
ethernet or vlan interface name that we want to configure PTP on it
state
-
    Choices:
  • enabled ←
  • disabled
Enable/Disable PTP on Interface
sync_interval
-
configure PTP sync interval, Range -7--1

Notes

Note

  • Tested on ONYX 3.6.8130

  • PTP Protocol must be enabled on switch.

  • Interface must not be a switch port interface.

Examples

- name: configure PTP interface
  onyx_ptp_interface:
    state: enabled
    name: Eth1/1
    delay_request: 0
    announce_interval: -2
    announce_timeout: 3

Return Values

Common return values are documented here, the following are the fields unique to this module:

Key Returned Description
commands
list
 always
The list of configuration mode commands to send to the device.

Sample:
['interface ethernet 1/16 ptp enable', 'interface ethernet 1/16 ptp delay-req interval 0', 'interface ethernet 1/16 ptp announce interval -1']


Status

Authors

  • Anas Badaha (@anasb)

Hint

If you notice any issues in this documentation you can edit this document to improve it.