onyx_vxlan – Configures Vxlan¶
New in version 2.8.
Synopsis¶
This module provides declarative management of Vxlan configuration on Mellanox ONYX network devices.
Parameters¶
| Parameter | Choices/Defaults | Comments |
|---|---|---|
|
arp_suppression
boolean
|
|
A flag telling if to configure arp suppression.
|
|
bgp
boolean
|
|
configure bgp on nve interface.
|
|
loopback_id
-
|
loopback interface ID.
|
|
|
mlag_tunnel_ip
-
|
vxlan Mlag tunnel IP
|
|
|
nve_id
-
/ required
|
nve interface ID.
|
|
|
vni_vlan_list
-
|
Each item in the list has two attributes vlan_id, vni_id.
|
Notes¶
Note
Tested on ONYX evpn_dev.031.
nve protocol must be enabled.
Examples¶
- name: configure Vxlan
onyx_vxlan:
nve_id: 1
loopback_id: 1
bgp: yes
mlag-tunnel-ip: 100.0.0.1
vni_vlan_list:
- vlan_id: 10
vni_id: 10010
- vlan_id: 6
vni_id: 10060
arp_suppression: yes
Return Values¶
Common return values are documented here, the following are the fields unique to this module:
| Key | Returned | Description |
|---|---|---|
|
commands
list
|
always |
The list of configuration mode commands to send to the device.
Sample:
['interface nve 1', 'interface nve 1 vxlan source interface loopback 1', 'interface nve 1 nve controller bgp', 'interface nve 1 vxlan mlag-tunnel-ip 100.0.0.1', 'interface nve 1 nve vni 10010 vlan 10', 'interface nve 1 nve vni 10060 vlan 6', 'interface nve 1 nve neigh-suppression', 'interface vlan 6', 'interface vlan 10']
|
Status¶
This module is not guaranteed to have a backwards compatible interface. [preview]
This module is maintained by the Ansible Community. [community]