onyx_vxlan – Configures Vxlan

New in version 2.8.

Synopsis

• This module provides declarative management of Vxlan configuration on Mellanox ONYX network devices.

Parameters

Parameter	Choices/Defaults	Comments
arp_suppression boolean	Choices: no ← yes	A flag telling if to configure arp suppression.
bgp boolean	Choices: no yes ←	configure bgp on nve interface.
loopback_id -		loopback interface ID.
mlag_tunnel_ip -		vxlan Mlag tunnel IP
nve_id - / required		nve interface ID.
vni_vlan_list -		Each item in the list has two attributes vlan_id, vni_id.

Notes

Note

• Tested on ONYX evpn_dev.031.

• nve protocol must be enabled.

Examples

- name: configure Vxlan
  onyx_vxlan:
    nve_id: 1
    loopback_id: 1
    bgp: yes
    mlag-tunnel-ip: 100.0.0.1
    vni_vlan_list:
      - vlan_id: 10
        vni_id: 10010
      - vlan_id: 6
        vni_id: 10060
    arp_suppression: yes

Return Values

Common return values are documented here, the following are the fields unique to this module:

Key	Returned	Description
commands list	always	The list of configuration mode commands to send to the device. Sample: ['interface nve 1', 'interface nve 1 vxlan source interface loopback 1', 'interface nve 1 nve controller bgp', 'interface nve 1 vxlan mlag-tunnel-ip 100.0.0.1', 'interface nve 1 nve vni 10010 vlan 10', 'interface nve 1 nve vni 10060 vlan 6', 'interface nve 1 nve neigh-suppression', 'interface vlan 6', 'interface vlan 10']

Status

• This module is not guaranteed to have a backwards compatible interface. [preview]

• This module is maintained by the Ansible Community. [community]

Authors

• Anas Badaha (@anasb)

Hint

If you notice any issues in this documentation, you can edit this document to improve it.