community.network.apconos_command – Run arbitrary commands on APCON devices

Note

This plugin is part of the community.network collection (version 2.1.1).

To install it use: ansible-galaxy collection install community.network.

To use it in a playbook, specify: community.network.apconos_command.

New in version 0.2.0: of community.network

Synopsis

  • Sends arbitrary commands to an apcon device and returns the results read from the device. The module includes an argument that will cause the module to wait for a specific condition before returning or timing out if the condition is not met.

Parameters

Parameter Choices/Defaults Comments
commands
list / elements=string / required
List of commands to send to the remote device over the configured provider. The resulting output from the command is returned. If the wait_for argument is provided, the module is not returned until the condition is satisfied or the number of retires as expired.
interval
integer
Default:
1
Configures the interval in seconds to wait between retries of the command. If the command does not pass the specified conditions, the interval indicates how long to wait before trying the command again.
match
string
    Choices:
  • any
  • all ←
The match argument is used in conjunction with the wait_for argument to specify the match policy. Valid values are all or any. If the value is set to all then all conditionals in the wait_for must be satisfied. If the value is set to any then only one of the values must be satisfied.
retries
integer
Default:
10
Specifies the number of retries a command should by tried before it is considered failed. The command is run on the target device every retry and evaluated against the wait_for conditions.
wait_for
list / elements=string
List of conditions to evaluate against the output of the command. The task will wait for each condition to be true before moving forward. If the conditional is not true within the configured number of retries, the task fails. See examples.

Notes

Note

  • Tested against apcon iis+ii

Examples

- name: Basic Configuration
  community.network.apconos_command:
    commands:
    - show version
    - enable ssh
  register: result

- name: Get output from single command
  community.network.apconos_command:
    commands: ['show version']
  register: result

Authors

  • David Lee (@davidlee-ap)