community.network.pn_vrouter_interface_ip module – CLI command to add/remove vrouter-interface-ip
Note
This module is part of the community.network collection (version 4.0.2).
You might already have this collection installed if you are using the ansible
package.
It is not included in ansible-core
.
To check whether it is installed, run ansible-galaxy collection list
.
To install it, use: ansible-galaxy collection install community.network
.
To use it in a playbook, specify: community.network.pn_vrouter_interface_ip
.
Synopsis
This module can be used to add an IP address on interface from a vRouter or remove an IP address on interface from a vRouter.
Parameters
Parameter |
Comments |
---|---|
interface Bridge Domain. |
|
Target switch to run the CLI on. |
|
IP address. |
|
netmask. |
|
virtual NIC assigned to interface. |
|
interface VLAN VNET. |
|
name of service config. |
|
State the action to perform. Use Choices:
|
Examples
- name: Add vrouter interface to nic
community.network.pn_vrouter_interface_ip:
state: "present"
pn_cliswitch: "sw01"
pn_vrouter_name: "foo-vrouter"
pn_ip: "2620:0:1651:1::30"
pn_netmask: "127"
pn_nic: "eth0.4092"
- name: Remove vrouter interface to nic
community.network.pn_vrouter_interface_ip:
state: "absent"
pn_cliswitch: "sw01"
pn_vrouter_name: "foo-vrouter"
pn_ip: "2620:0:1651:1::30"
pn_nic: "eth0.4092"
Return Values
Common return values are documented here, the following are the fields unique to this module:
Key |
Description |
---|---|
indicates whether the CLI caused changes on the target. Returned: always |
|
the CLI command run on the target node. Returned: always |
|
set of error responses from the vrouter-interface-ip command. Returned: on error |
|
set of responses from the vrouter-interface-ip command. Returned: always |