community.network.pn_vrouter_ospf6 module – CLI command to add/remove vrouter-ospf6
Note
This module is part of the community.network collection (version 4.0.2).
You might already have this collection installed if you are using the ansible
package.
It is not included in ansible-core
.
To check whether it is installed, run ansible-galaxy collection list
.
To install it, use: ansible-galaxy collection install community.network
.
To use it in a playbook, specify: community.network.pn_vrouter_ospf6
.
Synopsis
This module can be used to add interface ip to OSPF6 protocol or remove interface ip from OSPF6 protocol on vRouter.
Parameters
Parameter |
Comments |
---|---|
Target switch to run the CLI on. |
|
OSPF6 control for this interface. |
|
area id for this interface in IPv4 address format. |
|
name of service config. |
|
State the action to perform. Use Choices:
|
Examples
- name: Add vrouter interface nic to ospf6
community.network.pn_vrouter_ospf6:
pn_cliswitch: "sw01"
state: "present"
pn_vrouter_name: "foo-vrouter"
pn_nic: "eth0.4092"
pn_ospf6_area: "0.0.0.0"
- name: Remove vrouter interface nic to ospf6
community.network.pn_vrouter_ospf6:
pn_cliswitch: "sw01"
state: "absent"
pn_vrouter_name: "foo-vrouter"
pn_nic: "eth0.4092"
Return Values
Common return values are documented here, the following are the fields unique to this module:
Key |
Description |
---|---|
indicates whether the CLI caused changes on the target. Returned: always |
|
the CLI command run on the target node. Returned: always |
|
set of error responses from the vrouter-ospf6 command. Returned: on error |
|
set of responses from the vrouter-ospf6 command. Returned: always |