community.network.pn_vrouter_packet_relay module – CLI command to add/remove vrouter-packet-relay
Note
This module is part of the community.network collection (version 5.0.0).
You might already have this collection installed if you are using the ansible
package.
It is not included in ansible-core
.
To check whether it is installed, run ansible-galaxy collection list
.
To install it, use: ansible-galaxy collection install community.network
.
To use it in a playbook, specify: community.network.pn_vrouter_packet_relay
.
Synopsis
This module can be used to add packet relay configuration for DHCP on vrouter and remove packet relay configuration for DHCP on vrouter.
Parameters
Parameter |
Comments |
---|---|
Target switch to run the CLI on. |
|
forwarding IP address. |
|
protocol type to forward packets. Choices:
|
|
NIC. |
|
name of service config. |
|
vrouter-packet-relay configuration command. Choices:
|
Examples
- name: VRouter packet relay add
community.network.pn_vrouter_packet_relay:
pn_cliswitch: "sw01"
pn_forward_ip: "192.168.10.1"
pn_nic: "eth0.4092"
pn_vrouter_name: "sw01-vrouter"
- name: VRouter packet relay remove
community.network.pn_vrouter_packet_relay:
pn_cliswitch: "sw01"
state: "absent"
pn_forward_ip: "192.168.10.1"
pn_nic: "eth0.4092"
pn_vrouter_name: "sw01-vrouter"
Return Values
Common return values are documented here, the following are the fields unique to this module:
Key |
Description |
---|---|
indicates whether the CLI caused changes on the target. Returned: always |
|
the CLI command run on the target node. Returned: always |
|
set of error responses from the vrouter-packet-relay command. Returned: on error |
|
set of responses from the vrouter-packet-relay command. Returned: always |