Documentation

net_l2_interface – Manage Layer-2 interface on network devices

New in version 2.4.

Synopsis

  • This module provides declarative management of Layer-2 interface on network devices.

Parameters

Parameter Choices/Defaults Comments
access_vlan
-
Configure given VLAN in access port.
aggregate
-
List of Layer-2 interface definitions.
mode
-
    Choices:
  • access ←
  • trunk
Mode in which interface needs to be configured.
name
-
Name of the interface excluding any logical unit number.
native_vlan
-
Native VLAN to be configured in trunk port.
state
-
    Choices:
  • present ←
  • absent
State of the Layer-2 Interface configuration.
trunk_allowed_vlans
-
List of allowed VLAN's in a given trunk port.
trunk_vlans
-
List of VLANs to be configured in trunk port.

Notes

Note

Examples

- name: configure Layer-2 interface
  net_l2_interface:
    name: gigabitethernet0/0/1
    mode: access
    access_vlan: 30

- name: remove Layer-2 interface configuration
  net_l2_interface:
    name: gigabitethernet0/0/1
    state: absent

Return Values

Common return values are documented here, the following are the fields unique to this module:

Key Returned Description
commands
list
always, except for the platforms that use Netconf transport to manage the device.
The list of configuration mode commands to send to the device

Sample:
['interface gigabitethernet0/0/1', 'switchport mode access', 'switchport access vlan 30']


Status

Red Hat Support

More information about Red Hat’s support of this module is available from this Red Hat Knowledge Base article.

Authors

  • Ganesh Nalawade (@ganeshrn)

Hint

If you notice any issues in this documentation you can edit this document to improve it.