community.network.dladm_iptun – Manage IP tunnel interfaces on Solaris/illumos systems.
Note
This plugin is part of the community.network collection (version 3.0.0).
You might already have this collection installed if you are using the ansible
package.
It is not included in ansible-core
.
To check whether it is installed, run ansible-galaxy collection list
.
To install it, use: ansible-galaxy collection install community.network
.
To use it in a playbook, specify: community.network.dladm_iptun
.
Parameters
Parameter |
Comments |
---|---|
Literal IP address or hostname corresponding to the tunnel source. |
|
IP tunnel interface name. |
|
Literal IP address or hostname corresponding to the tunnel destination. |
|
Create or delete Solaris/illumos VNIC. Choices:
|
|
Specifies that the IP tunnel interface is temporary. Temporary IP tunnel interfaces do not persist across reboots. Choices:
|
|
Specifies the type of tunnel to be created. Choices:
|
Examples
- name: Create IPv4 tunnel interface 'iptun0'
community.network.dladm_iptun: name=iptun0 local_address=192.0.2.23 remote_address=203.0.113.10 state=present
- name: Change IPv4 tunnel remote address
community.network.dladm_iptun: name=iptun0 type=ipv4 local_address=192.0.2.23 remote_address=203.0.113.11
- name: Create IPv6 tunnel interface 'tun0'
community.network.dladm_iptun: name=tun0 type=ipv6 local_address=192.0.2.23 remote_address=203.0.113.42
- name: Remove 'iptun0' tunnel interface
community.network.dladm_iptun: name=iptun0 state=absent
Return Values
Common return values are documented here, the following are the fields unique to this module:
Key |
Description |
---|---|
local IP address Returned: always Sample: “1.1.1.1/32” |
|
tunnel interface name Returned: always Sample: “iptun0” |
|
remote IP address Returned: always Sample: “2.2.2.2/32” |
|
state of the target Returned: always Sample: “present” |
|
specifies if operation will persist across reboots Returned: always Sample: true |
|
tunnel type Returned: always Sample: “ipv4” |
Authors
Adam Števko (@xen0l)