community.network.pn_vrouter_loopback_interface – CLI command to add/remove vrouter-loopback-interface
Note
This plugin is part of the community.network collection (version 3.0.0).
You might already have this collection installed if you are using the ansible
package.
It is not included in ansible-core
.
To check whether it is installed, run ansible-galaxy collection list
.
To install it, use: ansible-galaxy collection install community.network
.
To use it in a playbook, specify: community.network.pn_vrouter_loopback_interface
.
Synopsis
This module can be used to add loopback interface to a vRouter or remove loopback interface from a vRouter.
Parameters
Parameter |
Comments |
---|---|
Target switch to run the CLI on. |
|
loopback index from 1 to 255. |
|
loopback IP address. |
|
name of service config. |
|
State the action to perform. Use Choices:
|
Examples
- name: Add vrouter loopback interface
community.network.pn_vrouter_loopback_interface:
state: "present"
pn_cliswitch: "sw01"
pn_vrouter_name: "sw01-vrouter"
pn_ip: "192.168.10.1"
- name: Remove vrouter loopback interface
community.network.pn_vrouter_loopback_interface:
state: "absent"
pn_cliswitch: "sw01"
pn_vrouter_name: "sw01-vrouter"
pn_ip: "192.168.10.1"
pn_index: "2"
Return Values
Common return values are documented here, the following are the fields unique to this module:
Key |
Description |
---|---|
indicates whether the CLI caused changes on the target. Returned: always |
|
the CLI command run on the target node. Returned: always |
|
set of error response from the vrouter-loopback-interface command. Returned: on error |
|
set of responses from the vrouter-loopback-interface command. Returned: always |
Authors
Pluribus Networks (@rajaspachipulusu17)