community.network.pn_ipv6security_raguard_port module – CLI command to add/remove ipv6security-raguard-port
Note
This module is part of the community.network collection (version 5.0.3).
You might already have this collection installed if you are using the ansible
package.
It is not included in ansible-core
.
To check whether it is installed, run ansible-galaxy collection list
.
To install it, use: ansible-galaxy collection install community.network
.
To use it in a playbook, specify: community.network.pn_ipv6security_raguard_port
.
Synopsis
This module can be used to add ports to RA Guard Policy and remove ports to RA Guard Policy.
Aliases: network.netvisor.pn_ipv6security_raguard_port
Parameters
Parameter |
Comments |
---|---|
Target switch to run the CLI on. |
|
RA Guard Policy Name. |
|
Ports attached to RA Guard Policy. |
|
ipv6security-raguard-port configuration command. Choices:
|
Examples
- name: Ipv6 security raguard port add
community.network.pn_ipv6security_raguard_port:
pn_cliswitch: "sw01"
pn_name: "foo"
pn_ports: "1"
- name: Ipv6 security raguard port remove
community.network.pn_ipv6security_raguard_port:
pn_cliswitch: "sw01"
pn_name: "foo"
state: "absent"
pn_ports: "1"
Return Values
Common return values are documented here, the following are the fields unique to this module:
Key |
Description |
---|---|
indicates whether the CLI caused changes on the target. Returned: always |
|
the CLI command run on the target node. Returned: always |
|
set of error responses from the ipv6security-raguard-port command. Returned: on error |
|
set of responses from the ipv6security-raguard-port command. Returned: always |