community.network.pn_vrouter_bgp_network module – CLI command to add/remove vrouter-bgp-network
Note
This module is part of the community.network collection (version 5.0.3).
You might already have this collection installed if you are using the ansible
package.
It is not included in ansible-core
.
To check whether it is installed, run ansible-galaxy collection list
.
To install it, use: ansible-galaxy collection install community.network
.
To use it in a playbook, specify: community.network.pn_vrouter_bgp_network
.
Synopsis
This module can be used to add Border Gateway Protocol network to a vRouter and remove Border Gateway Protocol network from a vRouter.
Aliases: network.netvisor.pn_vrouter_bgp_network
Parameters
Parameter |
Comments |
---|---|
Target switch to run the CLI on. |
|
BGP network mask. |
|
IP address for BGP network. |
|
name of service config. |
|
State the action to perform. Use Choices:
|
Examples
- name: Add network to bgp
community.network.pn_vrouter_bgp_network:
pn_cliswitch: "sw01"
state: "present"
pn_vrouter_name: "foo-vrouter"
pn_network: '10.10.10.10'
pn_netmask: '31'
- name: Remove network from bgp
community.network.pn_vrouter_bgp_network:
pn_cliswitch: "sw01"
state: "absent"
pn_vrouter_name: "foo-vrouter"
pn_network: '10.10.10.10'
Return Values
Common return values are documented here, the following are the fields unique to this module:
Key |
Description |
---|---|
indicates whether the CLI caused changes on the target. Returned: always |
|
the CLI command run on the target node. Returned: always |
|
set of error responses from the vrouter-bgp-network command. Returned: on error |
|
set of responses from the vrouter-bgp-network command. Returned: always |