ovirt_host_network – Module to manage host networks in oVirt/RHV¶
Requirements¶
The below requirements are needed on the host that executes this module.
- python >= 2.7
- ovirt-engine-sdk-python >= 4.3.0
Parameters¶
Notes¶
Note
- In order to use this module you have to install oVirt Python SDK. To ensure it’s installed with correct version you can create the following task: pip: name=ovirt-engine-sdk-python version=4.3.0
Examples¶
# Examples don't contain auth parameter for simplicity,
# look at ovirt_auth module to see how to reuse authentication:
# In all examples the durability of the configuration created is dependent on the 'save' option value:
# Create bond on eth0 and eth1 interface, and put 'myvlan' network on top of it and persist the new configuration:
- name: Bonds
ovirt_host_network:
name: myhost
save: yes
bond:
name: bond0
mode: 2
interfaces:
- eth1
- eth2
networks:
- name: myvlan
boot_protocol: static
address: 1.2.3.4
netmask: 255.255.255.0
gateway: 1.2.3.4
version: v4
# Create bond on eth1 and eth2 interface, specifiyng both mode and miimon:
- name: Bonds
ovirt_host_network:
name: myhost
bond:
name: bond0
mode: 1
options:
miimon: 200
interfaces:
- eth1
- eth2
# Remove bond0 bond from host interfaces:
- ovirt_host_network:
state: absent
name: myhost
bond:
name: bond0
# Assign myvlan1 and myvlan2 vlans to host eth0 interface:
- ovirt_host_network:
name: myhost
interface: eth0
networks:
- name: myvlan1
- name: myvlan2
# Remove myvlan2 vlan from host eth0 interface:
- ovirt_host_network:
state: absent
name: myhost
interface: eth0
networks:
- name: myvlan2
# Remove all networks/vlans from host eth0 interface:
- ovirt_host_network:
state: absent
name: myhost
interface: eth0
Return Values¶
Common return values are documented here, the following are the fields unique to this module:
Status¶
- This module is not guaranteed to have a backwards compatible interface. [preview]
- This module is maintained by the Ansible Community. [community]
Authors¶
- Ondra Machacek (@machacekondra)
Hint
If you notice any issues in this documentation, you can edit this document to improve it.